E10 Screw Bulb Led Short Round 6V to 12V DC. Virtually unbreakable, reliable performance. Available in super white, red, yellow, green, blue and rgb. 120 degree viewing angle. Uses only 20mA@13.8 Volts DC. Approximate size is .92in x .39in 10 mm(height x diameter). Fits T3 1/4, T3.25 size bulbs. E10 Miniature Screw Base. Short Round LED Light. 1 LED. Durable, shock and vibration proof, instant On/Off. Monochromatic (pure) color, low heat generation, . 6V to 12v DC. This LED lamp has built in ballast that allows the LED bulb to operate from 6V to 15V. Comparable to a 4 to 9 Watt incandescent led bulb. The bulbs works in negative ground or negative chassis cars, trucks, motorcycles, tractors and scooters. Up to 7 Lumen output. Long lasting life up to 30,000 hours. Mini indicator LED lamp. Dim-able using a dashboard dimmer knob. Great for instrument panels, mirrors, door panels, dashboard indicators, glove box, license plate. When replacing the alternator indicator warning for Triumph Spitfire, please make sure to add a load equalizer when replacing with LED or the alternator will not charge the battery. Please make sure to install the led load equalizer in parallel with the led light. For Excellent for DIY hobbies such as model railroad, doll houses, RC cars, bicycles. This is a screw in miniature bulb base uses such as above. This bulb is compatible with g15 led bulb e10 base 4.5v. Works from 3 Volts to 12 Volts. Dimmer at 3 Volts than 12 Volts.
Compatible with: 1487 GE 27356 LM1012MS-B 52 258 428 1446 1449 1487 Lucas 2.2w mes screw 1964 Rolls Royce Silver Cloud III MG MGA g15 4.5v 4.8v used for old Smith gauges LLB 987
| 5 Customer Reviews
|
| 5 Star: |
 |
4 |
Average Customer Rating
 4.8
out of 5 100% recommend it to
friends
|
| 4 Star: |
|
1 |
| 3 Star: |
|
0 |
| 2 Star: |
|
0 |
| 1 Star: |
|
0 |
Excellent dash bulb replacement!
by
wrightonman
from
Indianapolis
on
9/26/2011
Recommends it to Friends:
Yes
I cannot believe how much better I can see the gauges in my 1964 Land Rover! These were an exact fit and light the instrument panel up very nicely. Less AMPS going through the old Rovers electrical system also :) Too bad these were not invented when Lucas Electrics ruled British cars. I bet there would have been a few less electrical fires- lol
Thanks again for such a great product.
Andy (Updated on 9/26/2011.)
1
of
1
user
found this review helpful. Was this review helpful to you? YES /
NO
|
Excellent LED Dashboard Bulb
by
Perk
from
Auckland, New Zealand
on
6/18/2014
Recommends it to Friends:
Yes
I put these bulbs into the dashboard of my 1971 Series IIa Land Rover. They fit perfectly and do the job nicely. I would not recommend these bulbs for dashboard illumination (although they work, there are brighter bulbs available) but they are perfect for the warning lamps (e.g. headlight full beam, oil pressure etc).
If you are running a Lucas 15ACR or 17ACR alternator DO NOT use these bulbs for the Charge warning light unless you also wire a resistor into the circuit - the LED does not draw enough amps to activate the alternator and it will not charge.
1
of
1
user
found this review helpful. Was this review helpful to you? YES /
NO
|
Bright!
by
from
GA
on
5/12/2014
Recommends it to Friends:
Yes
Very bright LED bulds, shipped pronto. Used in my 1860 MGA map light.
Was this review helpful to you? YES /
NO
|
Fit could be better
by
Bruce
from
St. Pete, FL
on
3/21/2014
Recommends it to Friends:
Yes
The base of the 87965 bulb is slightly smaller in diameter than the original bulb (Osram). The panel light sockets in my MGA are not fully threaded, but have opposing ridges on the inside of the socket to catch the bulb threads. In order to get a snug, rattle-proof fit, I had to crimp the socket. The illumination is great.
Was this review helpful to you? YES /
NO
|
Not bright enough
by
Mike
from
Beaufort,S.C.
on
9/18/2013
Recommends it to Friends:
Yes
Bulb not bright but thats not your fault . I ordered the wrong bulb
Was this review helpful to you? YES /
NO
|
| |
Recommended Items: |
|
| |
| |
|
|
|
|
| |
| |
| |
|
|
|
|
| |
| |
| |
|
|
|
258 Led Bulb E10 Screw Flat 6V to 12V DC
|
| Product Code:
74276
|
| Price USD:
$0.97Quantity Pricing Available |
| |
|
Flat LED E10 Screw Base LED Bulb. 1 LED. Durable, shock and vibration proof, instant On/Off. Monochromatic (pure) color, low heat, virtually unbreakable. Available in super white, red, yellow, green and blue. 12 VDC. |
| |
|
|
| |
| |
| |
|
|
|
E10 Miniature Screw Concave LED Bulb 6 to 12 Volt DC
|
| Product Code:
79564
|
| Price USD:
$0.97Quantity Pricing Available |
| |
|
E10 Screw (T10) Concave LED Light. 1 LED. Durable, shock and vibration proof, instant On/Off. Monochromatic (pure) color, low heat, virtually unbreakable. Available in super white, red, yellow, green, blue, ultra violet and rgb. 12 VDC. |
| |
|
|
| |